Home

POM-C (Acetal Co-Polymer)

Also Known As

  • Kematal
  • Hostaform
  • Ultraform

Typical Machine Settings: Subject To Polymer Grade

Nozzle

Front

Centre

Rear

Barrel Temperature

195 - 220oC

190 - 205oC

190 - 205oC

190 - 205oC

Melt Temperature

195 - 230oC

Must be measured with a pyrometer by taking an airshot through the injection machine nozzle.

Hot Runner Temperature

195 - 230oC

Mould Temperature

85 - 105oC

Run at upper end of range for best surface finish.

Injection Rate

Medium To Fast

Specific Injection Pressure

700 - 1050 Bar (10,000 - 25,000psi)

Screw Back Pressure

2.0 - 3.5 Bar (30 - 50psi)

Screw Speed

Slow To Moderate

Processing Features

Structure

Semi-Crystalline

Specific Gravity

1.42

Viscosity

Medium

Needs average size runners.

Shear Rate Susceptibility

Medium

Needs average size gates.

Temperature Window

Narrow

Needs accurate & stable control

Residence Time

Short

Aim for '1-Shot' residence time

Start-Up Precedure
  • Ensure all heaters are thoroughly baked dry - do not rely on brief ‘soft start’ systems to do this.
  • Fast Heat controllers automatically and safely bakeout wet heaters - ask for details.
  • Turn on water lines to stabilise tool and manifold temperatures.
  • Turn on manifold control zone(s) and allow to warm up until measured value is within 10oC of setpoint.
  • Now turn on tip zones and allow to settle at setpoint for 5 - 10 minutes before starting production.
  • Take an airshot from the machine barrel and check that the melt temperature is correct.
  • Start moulding parts on a semi-automatic cycle until suitable machine settings are established.
  • Avoid lengthy delays between cycles during this setting procedure.
  • Switch to automatic cycle when parts are being produced, and fine tune the machine settings

Shut-Down Precedure
  • DO NOT shut down with Acetal in the machine barrel of hot runner system.
  • Purge the barrel thoroughly with Polystyrene or other recommend polymer.
  • Now start moulding parts in the purging material until all drops are clear of Acetal.
  • DO NOT attempt to purge through an open mould, or melt leakage my result.
  • Shut down the machine & mould when ALL of the Acetal has been cleaned out.