PP (Polypropylene)

General Moulding Notes

Pp requires a cool gate area - excessive gate heat may cause stringing and part surface distortion.
Small gate diameters are generally suitable.
Gate vestige is usually neat, typical height 1/3 - 1/2 of gate diameter.
Filled polymers may require special wear resistant tips - check with factory.

Code	Tip Style	Suitability	Comments
Sprue Tips For Gating On Runners
SS	Short Sprue	Good
XS	Extended Sprue	Good
NS	Nylon Sprue	Fair	Prone to stringing.
NX	Nylon extended sprue	Fair	Prone to stringing.
Pin Gate Tips For Gating On Parts
PP	Pinpoint	Good	Gives minimal gate pip, no witness ring.
PX	Pinpoint Extended	Good	Gives minimal gate pip, no witness ring.
PT	Pinpoint thru' flow	Fair	As above. Gate pip height may increase.
EXT	Extended Hot Pinpoint	Good	Gives minimal gate pip, no witness ring, high pressure drop.
RG	Ring Gate	Good	Leaves witness ring on part.
RT	Ring Gate thru' flow	Fair	As above. Gate pip height may increase.
CG	Collar Gate	Good	Gives minimal gate pip, no witness ring.
CT	Collar gate thru' flow	Fair	As above. Gate pip height may increase.
Valve Gate Tips For Gating On Parts
VP	Valve pinpoint gate	Good	No witness ring on part, gate area must be cool.
VR	Valve ring gate	Fair	Leaves witness ring on part, gate area must be cool.
VC	Valve collar gate	Good	No witness ring on part, gate area must be cool.
Special Gate Tips For Gating On Parts
MT	Multi-Tip	Good	Not suitable for frequent colour changing.
TG	Tunnel Gate	Good	Not suitable for frequent colour changing.

Find the bush size that most closely matches your required shot weight with your choice of tip and click on the shot weight to be taken to the technical data for that range.
If approaching the maximum for a particular bush size, consider using the next larger size, especially if a long bush is required.
Polymer grade, viscosity, fillers and part dimensions also affect the choice of bush. If in doubt - ask.
O = This tip / bushing combination is not currently available.
X = This selection is not recommended.

Code	Multi-Tips		MT32D	MT45D
MT	Multi-tip Pinpoint		50	50

Code	Tunnel Gate Tips		DT18	DT25	DT32A	DT32C
TG	Tunnel Gate thru' flow		50	50	O	O